GTA Range
DualSense haptics range · 38 weapons

PS5 controller drift test for the DualSense

Put the controller down and watch. A healthy stick rests within a few percent of centre; a drifting one sits further out, or wanders. This test shows exactly where each of your DualSense’s sticks rests, how much it moves on its own, and the dead zone that would hide it. It runs in your browser, over USB or Bluetooth.

Loading the drift test Connect your DualSense with a USB-C cable, or pair it over Bluetooth, while it loads.

Updated

How to test a PS5 controller for stick drift

  1. Connect the DualSense to your computer with a USB-C cable, or pair it over Bluetooth: hold Create and the PS button until the light bar flashes, then pick it in your Bluetooth settings.
  2. Press any button on the controller. Your browser then shows its sticks. In Chrome, Edge or Opera you can also press Connect DualSense to see its battery and model.
  3. Put the controller on a flat surface and let go of both sticks. Watch the live monitor for ten seconds: the lines should stay low and flat.
  4. Press Check for stick drift for a three-second measurement of both sticks.
  5. Roll each stick slowly around its edge to draw its range. Then click each one in, to check L3 and R3.

What the results mean

  • Under 6% from centre: no drift. A healthy stick rests within a few percent of centre.
  • 6 to 15%: slight drift. Most games ignore movement this small, because it’s inside their dead zone. It can show up in games with a small dead zone.
  • Over 15%: drift that games will notice: a character that walks or a camera that turns on its own.

A dead zone is the area around centre that a game ignores. Many games let you set its size in their controller settings. When a stick drifts, the live monitor suggests the smallest dead zone that would hide it. A bigger dead zone costs a little precision, so it’s a workaround rather than a fix.

The outline shows how far each stick reaches in every direction. Compare the two: a flat side, or a much bigger edge error on one stick, means it can’t reach full travel that way, which games read as a slower walk or turn.

What causes stick drift

Stick drift usually comes from wear or dirt in the sensors that read each stick’s position. It tends to start small and get worse over time, which is why a stick that seemed fine can begin to wander after a few months of heavy use.

How to fix stick drift

  • Roll the stick around its edge a few times, then measure again. Mild drift sometimes settles.
  • With the controller off, blow short bursts of compressed air around the base of the stick.
  • Reset the controller with the small button in the hole on its back, then reconnect it.
  • Raise the dead zone in the games you play, to the size the monitor suggests.
  • If the controller is under warranty, contact PlayStation Support. On a DualSense Edge, the stick modules can be replaced.

Stick drift and GTA 6

GTA 6 comes out on 19 November 2026 (see the countdown). In a game where you walk, drive and aim with the sticks, drift shows up fast: a drifting left stick steers on its own, and a drifting right stick drags your aim. If yours drifts, it’s worth sorting out before launch day.

Questions

Can I test for stick drift without a PS5?

Yes. Connect the controller to a computer and use this page. No console, app or driver is needed.

Does it work over Bluetooth, on a Mac, or in Firefox?

Yes. The sticks are read through the browser’s Gamepad API, which most desktop browsers support, over USB or Bluetooth. If a browser doesn’t know the controller’s layout, the tester says so.

Does it test other controllers?

The sticks, yes: it reads any controller your browser lists as a gamepad, including Xbox controllers. The battery and model readout needs a DualSense or DualSense Edge.

How accurate is it?

It shows each stick’s position as the controller reports it, to three decimal places, with no dead zone of its own, so even small resting offsets show up.